Adding A Ceiling Light To A Room

Wiring a ceiling light fixture electrical question.

Adding a ceiling light to a room.

Locate a source of constant power near where the light fixture will be located. How to light a room with string lights. How to install lighting in a room with no overhead lights placing the fixture and light switch. Adding a ceiling fixture where none existed before entails bringing power to a wall switch.

Choose the fixture first. Insert a wire through the hole up to the attic. There are diagrams for adding lights to a ceiling fixture you already have and for using an existing wall outlet as the source for a new switch and light. This might be an outlet in the room or it might be in an attic above the room.

Turn off all power supply to the room in which you will be working. Do not cut into the insulation on the wires inside the cable sheath. This is a two story house and some work is on the 1st floor as well as the 2nd floor. In the new homes in this area they no longer install an overhead light in the bedrooms.

Map out your ceiling draw a sketch of your ceiling and map out where the outlets in the room are draw a sketch of your ceiling and map out where the outlets in the room are plan how you want to hang the lights there are tons of design ideas out there you could. Draw an imaginary line that runs between the ceiling hole and the wall hole and cut a small. When originally built they installed a switch as you walk into the bedrooms but that powers a receptacle in that room not a ceiling light. After you ve determined that the existing switch box will work to power the new light it s time to shop for the sconce and pick up the remodeling box cable and electrical connectors you ll need.

Pull the wires into the electrical boxes and mount the boxes into the ceiling and wall according to the manufacturer s instructions. Check that there is no power running through the wires with a circuit tester. A ceiling fixture that operates off a switch when you enter a room is a convenient way to light a room. Then pick a rectangular or round remodeling box that is small enough to be covered by the light fixture canopy.

Take a look at the box in the ceiling and make sure it is sturdy enough to hold a heavy vibrating fan. Different wiring arrangements are included to allow for either the light or the switch to come first in the circuit.